Yamaha Rio3224-D2 Owner's Manual page 28

Troubleshooting
SYNC Messages
Message
NORMAL
SYNCHRONIZATION
WRONG WORD CLOCK!
DANTE PORT DOES NOT
HAVE CONNECTION!
DANTE CONNECTION
ERROR!
DANTE IS NOT WORKING
BY GIGA BIT!
DANTE IS WORKING AT
SECONDARY!
ERROR OCCURRED AT
SECONDARY PORT!
DANTE WORD CLOCK
MASTER
DANTE IS NOT WORKING
BY GIGA BIT!
DANTE IS WORKING AT
SECONDARY!
ERROR OCCURRED AT
SECONDARY PORT!
* If the ID is blank, the message is shown. Otherwise, the ID is shown.
28
ID * Description
Operating normally
Currently processing synchronization within
the Dante network.
E01-03 The word clock setting is incorrect.
E01-04 The Dante network is not connected.
E01-05 Other Dante devices cannot be found
because the Dante network connections are
incorrect.
E01-06 A device that does not support gigabit
Ethernet is connected.
E01-07 In the case of a redundant network,
communication is occurring via the
[SECONDARY] port.
E01-08 In the case of a redundant network, a problem
has occurred in the circuit that is connected to
the [SECONDARY] port.
Functioning correctly as the word clock
master.
E01-10 Functioning correctly as the word clock
master.
A device that does not support gigabit
Ethernet is connected.
E01-11 Functioning correctly as the word clock
master.
In the case of a redundant network,
communication is occurring via the
[SECONDARY] port.
E01-12 Functioning correctly as the word clock
master.
In the case of a redundant network, a problem
has occurred in the circuit that is connected to
the [SECONDARY] port.
Owner's Manual
Possible Solution
– – –
Wait until startup or synchronization is
completed. It may take up to 45 seconds for
this to be completed.
On the Rio2-native device or in Dante
Controller, set the clock master and the
sampling frequency correctly.
Check whether an Ethernet cable might be
disconnected or broken.
Check whether the Ethernet cable
connections are correct.
If you are conveying audio via Dante, use
devices that support gigabit Ethernet.
Check the circuit that is connected to the
[PRIMARY] port.
Check the circuit that is connected to the
[SECONDARY] port.
This indicates that the device is the word clock
master.
This indicates that the device is the word clock
master.
If you are conveying audio via Dante, use
devices that support gigabit Ethernet.
This indicates that the device is the word clock
master.
Check the circuit that is connected to the
[PRIMARY] port.
This indicates that the device is the word clock
master.
Check the circuit that is connected to the
[SECONDARY] port.