SERVICE MANUAL HW60-12266AS Chapter 5 Wiring circuit to M C U G N D to M C U W F M fro m M C U G N D fro m M C U to M C U to M C U...
Page 11
SERVICE MANUAL HW60-12266AS Delay at the same time 1490/1480/1470/147P/1460/1450/1290/1280/1270/127P/1260/1250/1090/1080/1070/107P/1060/1050 0266A 1260 1060 Front Load Washing Machine...
Set The wire between PCB spin program to start. Check the export and drain pump is not voltage to drain pump, is it between AC connected properly. 220-240V? Replace the wire. Replace PCB Haier Front Load Washing Machine...
Page 14
Cut off power, check the resistance of be broken, please pins heater element replace it multimeter, is it between 27-30 ? The control wire may be broken, Otherwise the PCB must be broken; Please replace the broken. Haier Front Load Washing Machine...
Page 15
The wire connected PCB and inlet valve is not Check if export voltage from PCB to properly. Please reconnect it or replace it. electromagnetic valve (between X2-3 and X1-1), is it between AC 220-240V? Replace PCB Haier Front Load Washing Machine...
Page 16
Without power ,connect inlet pipe to inlet valve, then open the tap and observe if Replace inlet valve water is entering in dispenser Without starting but electrifying, measure Replace PCB the import voltage of inlet valve, is it between AC 220-240V? Haier Front Load Washing Machine...
Page 17
Without power ,check if the line make sure the machine of PCB is connected well? can work. Change the PCB. Switch on the power and check if the export voltage from PCB to water level sensor is not 5V? Haier Front Load Washing Machine...
Replace electromagnetic valve there open circuit between electromagnetic valve and PCB? Reconnect the wire Choose pre-wash program and start, Replace PCB then check if there is 220-240V at export pin of electromagnetic valve Haier Front Load Washing Machine...
If it is broken, replace it. Replace motor Turn on power and set spin program, then start, check if there is different noise from motor Haier Front Load Washing Machine...
Is water leaking from outer cylinder? 7-4. Parameter of primary electronic appliance The rated voltage , current and frequency of motor The rated voltage of motor is 200~240V,rated current of motor is 6A,rated frequency of motor is 50/60Hz, Heater Haier Front Load Washing Machine...
Page 21
SERVICE MANUAL HW60-12266AS Front Load Washing Machine...
Page 22
SERVICE MANUAL HW60-12266AS Front Load Washing Machine...
Page 23
SERVICE MANUAL HW60-12266AS Dismantle the motor Release the two screws on the Motor bracket. Pull the motor along the arrowhead, then take off the motor. Dismantle shock absorber shock absorber Pull out the pin of shock absorber, then take off the bolt and washer of on the cabinet The pins can not be used again.
Page 24
SERVICE MANUAL HW60-12266AS Front Load Washing Machine...
Page 25
SERVICE MANUL HW60-12266AS Group Haier Industrial Park, No.1, Haier Road 266101, Qingdao, China http://www.haier.com Front Load Washing Machine...