Configure Wpa-Personal (Ap Mode) - D-Link DAP-1525 User Manual

Section 4 - Wireless Security

Configure WPA-Personal (AP Mode)

It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by opening a web
browserand entering the IP address of the access point
(192.168.0.50). Click Setup and then Wireless Settings
on the left side.
2. Select Enable WPA/WPA2 Wireless Security (enhanced)
from the Security Mode drop-down menu.
3. Select Auto(TKIP/AES), TKIP, or AES from the Cipher
Type drop-down menu. If you have wireless clients that
use both types, use TKIP/AES.
4. Select PSK from the PSK / EAP drop-down menu.
5. Enter a key (passphrase) in the Network Key field. The key is entered as a pass-phrase in either ASCII or HEX
format. If using ASCII format the pass-phrase must be between 8-63 characters. If using HEX format the pass-phrase
must be 64 characters. The ASCII or HEX pass-phrase must be the same at both ends of the wireless connection.
6. Click Save Settings to save your settings. If you are configuring the Access Point with a wireless adapter, you will
lose connectivity until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the
Access Point.
D-Link DAP-1525 User Manual 58