Configure Wep (Bridge Mode) - D-Link DAP-1525 User Manual

Section 4 - Wireless Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by opening a web
browser and entering the IP address of the access point
(192.168.0.50). Click Setup and then Wireless Settings
on the left side.
2. Select Enable WEP Wireless Security (basic) in the
Security Mode drop-down menu in the Wireless Security
Mode section.
3. Next to WEP Encryption in the WEP section, select the
level of encryption (64-bit or 128-bit). Hex - (recommended)
Letters A-F and numbers 0-9 are valid.
4. Next to Default WEP Key and the first selection in the
drop-down menu, WEP Key 1. Enter a WEP key that you
create in the WEP Key value and Verify WEP Key value
fields. Make sure you enter this key exactly on all your wireless devices. You may enter up to 4 different keys using
the Default WEP Key drop-down menu.
5. Click Save Settings to save your settings. If you are configuring the access point with a wireless adapter, you will
lose connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the access point.
D-Link DAP-1525 User Manual

Configure WEP (Bridge Mode)

60