1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
4 Disassembly and Assembly Instructions 4.1. Disassembly Instructions Follow the procedure below to disassemble the main unit. 1. Remove the cap, the outer foil and the inner blade. 3. To remove the trimmer driving bar or the slit blade driving bar, press bars outward.
Page 6
5. Take out the battery from the chassis. 7. Move gently the linear motor assembly down and unhook it and remove the float springs from housing A. 6. Take out the tube holder. 8. Unsolder the lead wires from the module.
Page 7
4.2. Caution in Assembly NOTE: When reassembling, replace the new waterproof seal. Make sure whether there is NO foreign substance sticking around a part covered with waterproof seal. 1. Solder the lead wires with the module. 3. Twist the lead wires and place them in the ribs. NOTE: Make sure of the color of lead wires.
Page 8
4. Set the linear motor assembly on the housing A and slid- 6. Tighten the six screws. ing it upward to hook. Confirm that the lead wire tube fits NOTE: Make sure to attach the connecting plate. to the housing A firmly and no foreign substance sticking around.
Page 9
8. Attach the bottom cover and tighten a screw. 10. Set the trimmer where removing it and click the hook. If the position is not properly, it makes the deformation of the hook. 9. Set the trimmer driving bar and the slit blade driving bar.
6 Exploded View and Replacement Parts List Model No. : ES-LT41 Exploded View...
Page 12
Model No. : ES-LT41 Parts List Ref. Safety Part No. Part Name & Description Q'ty Remarks WES8119X7158 PROTECTIVE CAP 1 [BG] WESLT50S0047 OUTER FOIL FRAME 1 [BG] WES9087PC OUTER FOIL WES9068PC INNER BLADE WESLT41L1008 LINEAR MOTOR ASSEMBLY 1 [BG] WES8119L1087...