Sanyo DMP-M400SD Instruction Manual page 30

Symptom
Possible cause
Corrective action
The Removable Disk is not displayed when the unit is connected to the PC.
The PC and the unit are not connected correctly.
Make sure the connect is corrected.
Disconnect the unit from the PC and reconnect it again.
Sufficient power is not being supplied from the PC.
If a USB hub is being used, reconnect the unit directly to the USB port on the
PC. If the PC is equipped with several different USB ports, try another port.
The USB driver is not installed properly.
Check the installation (only for Windows 98SE operating systems, see page
9).
A network drive has been assigned.
If a network drive has been assigned, the drive letter (the letters used as drive
names) is already taken, so the Removable Disk cannot be created. Change
the network drive assignments and reconnect. Talk to your network
administrator about reassigning network drives.
A file can't be deleted.
The attribute of the file is set up only for reading.
Please delete a file whether connects this to a PC and changes file attribute.
Or please do format of SD card.
Protect the SD card.
Unlock the protect of SD card.
GB-29
[ENGLISH]