Page 1
The lamp warning light ashes red (the lamp is burnt out). Contact your dealer or call Epson at 800-GO-EPSON (800-463-7766). Request part number V13H010L50. Replacing the Lamp 1. Turn o the projector.
Page 2
INSTALLATION HANDBOOK Epson PowerLite 84 Lamp and Status Information 5. Loosen the two screws holding the lamp in place (you can’t remove them). Loosen, but don’t remove these screws 6. Hold the lamp as shown and pull it straight out.
INSTALLATION HANDBOOK Epson PowerLite 84 Lamp and Status Information 9. Once the lamp is fully inserted, tighten its screws. 10. Replace the lamp cover, then tighten its screw. 11. Reset the lamp timer as described page . Resetting the Lamp Timer After you replace the lamp, you need to reset the lamp timer using the projector’s menus.