Panasonic AW-HR140PJ Operating Instructions Manual page 11

How to install and connect the unit (continued)
3.
Remove the two pin fixing screws and remove the pins
at the mechanism endpoint.
Positions of pins for stand-alone installation
Pins at mechanism end point
Pin fixing screws (M2 with hexagon socket heads)
4.
Switch over the pins at the mechanism end point
between the left and right and then reattach the pin
fixing screws.
Positions of pins for suspended installation
Pins at mechanism end point
Pin fixing screws (M2 with hexagon socket heads)
5.
Rotate the camera head 180 degrees in the direction
of the arrow so that the top and bottom of the camera
head are reversed and then attach the reinforcement
arm cover to the body.
Reinforcement arm cover
6.
• The rotation range is now switched to 180 degrees so rotation
175 degrees left and right is possible when the unit is in a suspended
installation state.
• To return to the stand-alone installation state, perform the work with
the procedure in reverse to switch over the pins at the mechanism end
point between the left and right.
<NOTE>
• Configurations are set for stand-alone installation under the factory
settings.
Be sure to perform the following when using the suspended installation
method.
1) Change the pins at mechanism end point
2) Set [Install Position] to [Hanging] in the camera menu (→ PDF
3) Restart the unit (disconnect the power supply to the unit before
Perform operations similar to the above for stand-alone installation
when switching back from a suspended installation to a stand-alone
installation.
• Selecting the wrong setting for [Install Position] may result in contact at
the edges of the movement range and malfunction.
Camera head
Install the unit suspended.
For the installation procedure, refer to the preceding "Performing
the installation surface work" (→ page 8) to "Suspended
installation" (→ page 10).
page 48 and page 80)
connecting it again)
Installation Instructions
11