NEC SL2100 Quick Install Manual page 27

Configure the SL2100
Detected Trunk Type
Will show the trunk cards installed within the SL2100 system, in this example only Analogue trunks are installed.
Click the 'Analogue Trunks' button to continue.
For each trunk line, you can configure two Targets and two Modes. Additional Modes can be configured outside
of the Initial Setup Wizard.
Mode1 is usually daytime operation
Mode2 is usually night time operation
You can configure two targets for each trunk line. T1 is the first target, this is a Ring Group which contains
telephone extensions. The timer icon shows how long between each target. In this case the call will ring for 10
seconds before going from Target 1 to Target 2.
Quick Install Guide – SL2100 with Analogue Trunks rev 1.1
27