Class B (Style Y) Input/Output Nac Wiring - Siemens PAD-4 Installation, Operation And Maintenance Manual

2.6.3

Class B (Style Y) Input/Output NAC Wiring

Figure 2-12 shows how to wire for Class B (Style Y) input and output supervision. Use in/out wiring
methods for proper supervision.
Class B (Style Y) Output Notification Circuits
Figure 2-12 shows four, 1.5 amp devices wired as Class B (Style Y) circuits.
Place a 24K ohm EOL resistor (provided) at the end of each loop to enable notification output supervi-
sion when using all outputs as Class B (Style Y) notification circuits. The 24K EOLs must be wired to the
terminals whether or not you are using all output terminals.
Class B (Style Y) Supervised Input Circuits
Figure 2-12 shows Class B (Style Y) supervised wiring from a fire alarm control unit to the PAD-4 board.
Use the control unit's EOL resistor installed as shown to enable notification input supervision. Note:
MIN: 22 AWG, MAX: 12 AWG.
TB11
1+ 1- 1 2+
1
INPUT 1
FOR TB11 INPUT 1(-) AND
TB12 INPUT 2(-) USE TWO
CONDUCTORS UNDER
ONE SCREW TERMINAL.
THIS SCREW TERMINAL
REQUIRES 16-22 AWG
FOR MULTIPLE
CONDUCTOR USAGE.
24VDC/VFW
7mA MAX.
SUPERVISED BY
FIRE ALARM
CONTROL UNIT,
POWER LIMITED
TB12
TB13
2- 2 COM NC NC COM NO
1 1
INPUT 2
EOL
(SEE CONTROL UNIT
INSTALLATION INSTRUCTIONS)
-
+
CLASS B (STYLE Y)
NOTIFICATION OUTPUT
FROM FIRE PANEL
POLARITY SHOWN IN
ACTIVATED CONDITION.
Class B (Style Y) Supervised Input/Output Connections
PAD-4 Installation, Operation and Maintenance Manual
TB14
_ _
+ +
NAC1B NAC2B (NAC1A)
1
- -
+ +
- -
+ +
24K, 1/2W
PART NO.
140-820405
NAC RATINGS:
ALARM VOLTAGE: 24VDC
MAX. ALARM CURRENT: 3A
MAX. RIPPLE: 0.1 VAC
MAX. STANDBY CURRENT: 1.0mA
Figure 2-12
TB15 TB16
_ _ _
+ + +
NAC3B NAC4B (NAC2A) AUX PWR SUPPLY
1 1
- -
+ +
- -
+ +
24K, 1/2W
NOTIFICATION APPLIANCE CIRCUIT
PART NO.
CLASS B ( STYLE Y)
140-820405
SUPERVISED, POWER LIMITED
SEE SIEMENS P/N 315-096363 OR
FARADAY P/N 315-096363FA FOR
COMPATIBLE DEVICES
POLARITY SHOWN IN
ACTIVATED CONDITION.
13