Table of Contents
Advertisement
8
Advanced Scanner Configuration Guide
Beeper Tone
To select a decode beep frequency (tone), scan the appropriate bar code.
Low Frequency
*Medium Frequency
High Frequency
Beeper Frequency Adjustment
This parameter adjusts the frequency of the high beeper tone from the nominal 2500 Hz to another frequency matching
the resonances of the installation. It is programmable in
10 Hz increments from 1220 Hz to 3770 Hz.
To increase the frequency, scan the bar code below, then scan three numeric bar codes beginning on page 51 that
correspond to the desired frequency adjustment divided by 10. For example, to set the frequency to 3000 Hz (an
increase of 500 Hz), scan numeric bar codes 0, 5, 0, corresponding to 50, or (500/10).
To decrease the frequency, scan the bar code below, then scan three numeric bar codes beginning on page 51 that
correspond to the value (256 - desired adjustment/10). For example, to set the frequency to 2000 Hz (a decrease of 500
Hz), scan numeric bar codes 2, 0, 6, corresponding to 206, or (256 - 500/10).
To change the selection or cancel an incorrect entry, scan the
Cancel
bar code on page 51.
Beeper Frequency Adjustment
(Default: 2500 Hz)
Revision: 2.0 , technical changes excepted
Advertisement
Table of Contents
