JVC KD-AV7005 Service Manual page 11

3.1.5 Removing the rear bracket
(See Figs.10)
• Prior to performing the following procedures, remove the dis-
play unit, detach panel assembly, front panel assembly and top
drive unit.
From the rear side of the main body, remove the five screws G
attaching the rear bracket.
3.1.6 Removing the DVD mechanism assembly
(See Figs.11 and 12)
• Prior to performing the following procedures, remove the dis-
play unit, detach panel assembly, front panel assembly and top
drive unit.
(1) From the top side of the main body, release the lock of the
connector CN52 on the main board in an upward direction
and disconnect the flexible wire. (See Fig.11.)
(2) Remove the two screws H and screw J attaching the mech-
anism cover. (See Fig.11.)
(3) Release the lock of the connector
board in an upward direction and disconnect the card wire.
(See Fig.12.)
Reference:
When connecting the card wire to the connector CN101, pass
it through the lower part of the mechanism bracket. (See
Fig.12.)
CN101 on the main
Rear bracket
Fig.10
Flexible wire
Mechanism cover
H
CN52
J
Fig.11
DVD mechanism assembly
Main board
CN101
Fig.12
G
H
Main board
Mechanism bracket
(No.MA101)1-11