Table of Contents
Advertisement
Receiving e-mails and other data automatically
in real-time (e-mail push)
E-mail push
If you have a data connection to a mobile network provider (GPRS/UMTS) for your Pocket
PC then your e-mails, calendar data, contact data, tasks etc. can be delivered from
the network to your Pocket PC in real-time via e-mail push.
If your device is switched off (Standby mode) when new data are received via
e-mail push, then the LED will start to flash.
The following conditions must be met in order to use e-mail push:
•
The server must support e-mail push.
•
Exchange Server 2003 Service Pack 2 is installed.
Direct Push has been set up by your administrator on your Pocket PC.
•
Please consult your administrator if you have any queries.
In general, e-mail push should already be activated on your device after
being set up by the administrator.
To deactivate e-mail push, you will need to deactivate the corresponding profile on your Pocket PC:
► In the Today screen, press and hold the End button.
The profile list is displayed.
► Select the Direct Push profile.
The profile is deactivated.
E-mail push is deactivated.
► To reactivate e-mail push, select the Direct Push profile again.
The profile is activated.
Detailed information on adjusting the device behaviour when e-mail push
is activated can be found in the
E-mail push is activated", Page 73
A26391-K182-Z120-1-7619, edition 2
"Configuring device behaviour when
chapter.
Creating messages
59
Advertisement
Table of Contents
