Before First Use; Wash Setting; Standard Washing; Removing Washing (Once Programme Is Finished) - Kenwood K1016WM17 Installation And Instruction Manual

Spin Only
Speed Waeh
O
Cotton
Synthetic
Baby Care
Jeans
Mix
colours
Drain Only
Fa-uriteo
Colton EcoQ
• • Hand Wash
Sport Wear
Express
Delicate
Wool
Rinse & Spin
before first use
Before washing your clothes for the first time, run a full wash programme first:
1. Connect the machine to the mains power supply and the water supply.
2. Put a small amount of detergent in the detergent drawer. Close the drawer.
3. Press the On/Off button.
4. Select a wash programme.
5. Press the Start/Pause button.
wash setting
standard washing
1. Pull the door handle and put the laundry in the drum.
(Refer to Preparation to sort your laundry before it goes
into the drum.) Make sure no washing gets caught in the
door.
2. Close the door and press the On/Off button. Turn
the Programme Selection Dial to select your wash
programme.
3. Select the temperature, spin speed and other functions if
desired.
4. Add detergent into the detergent drawer. The quantity
of detergent will depend on the amount of laundry,
the degree of soiling and the water hardness. Use the
amount of detergent suggested on the packaging.
5. Press the Start/Pause button to start the washing.
6. The washing machine will sound when the programme is
complete.
Q
t,
If the door is locked and you switched the washing machine off and then on - or if there's a
power cut - it will stay locked for 5 seconds.
removing washing (once programme is finished)
O
Door remains locked for 1 minute after wash stopped.
• Open the washing machine door and remove your washing.
•
Remove any foreign objects to avoid risk of rusting.
• Leave the door and detergent drawer open so that residual water can evaporate.
16