Advertisement
POWER CORD
SIGNAL CABLE
O
o
0 0
DG-5
o
SECTION 3. OPERATING INSTRUCTIONS
3-1 CONNECTION WITH TS-520S (see
Figure 3)
Interconnection of your DG-5 with the
mother equipment, or your TS-520S can be
completed by plugging the signal cables and
power cord onlyas shown in Figure 3. Notice that
the DG-5 and TS-520S are different in the order
of the connectors. Be careful of inserting the
pin plug of each coaxial signal of the same color
into the connectors of the same reference. The
DG-5 orders the HET, VFO, and CAR con-
nectors, and the TS-520S the VFO, HET, and
CAR connectors as viewed toward the rear
panels. Correct connection allows the DG-5 to
work immediately when the TS-520S POWER
switch is turned on.
The DG-5 is designed to well match with the
TS-520S when placed on it.
3-2 OPERATION FOR FREQUENCY
DISPLAY
The DG-5 operates with the HET, V FO, and
CAR signals as well as the DC power supplied
from the TS-520S. The DG-5, therefore, displays
the operating frequency as controlling the
TS-520S. The following describes how to use
the TS-520S controls in connection with appro-
priate operations and checking of the DG-5.
1. Set-up
DG-5:
Set the DISPLAY-COUNTER se-
lector to DISPLAY.
Set the DH switch to OFF.
TS-520S: Set in the receive mode of opera-
tion. Set the SG switch on the
rear panel to OFF to avoid
transmitting any undesirable wave
during checking.
Figure 3. Interconnection of DG-5 with TS-520S
6
Advertisement
