Mitsubishi Electric MELDAS 600 Series Instruction Manual page 13

'.
The following shows an execution example when setting the information area in the on-board
SHAM.
>j 2.1 fEnter]
OnBoard HR113B Sram --> C-Bus#2 HR437B From size=ox60000
Write ? (YES:Y(y) I NO:N(n)] --> y lEnter1
Erase
I=1
Programming
b+l
Compare
OK
Set Comment --> 123456789012345 fEntar
Erase
bl
Programming
14,
Compare
OK
>
a) The on-board SRAM is backed up in block # 1 of the backup cassette.
b) The selected memory and backup cassette card name, memory type, and copy size is
displayed.
c) This is for confirming the execution. Writing begins if Y is selected.
d) The FROM is erased. 'p>>>]" shows that the operation is being executed.
e) The data of the selected memory is written.
l
[D>>]* shows that the operation is being
executed.
f) The written data is compared with the original data.
g) "OK' is displayed if the writing finishes correctly.
h) The comment is input.
i) The information area is erased. '[>>>>]' shows that the operation is being executed.
j) The new information data is written to the information area. '[>x+>]" shows that the operation
is being executed.
k) The written data is compared with the original data.
I) 'OK" is displayed if the writing finishes correctly.
-lO-