Starting And Ending The M6 Maintenance Tool; Starting The Tool; Ending The Tool - Mitsubishi Electric MELDAS 600 Series Instruction Manual

..:
3. Starting and Ending the M6 Maintenance Tool
3.1 Starting the tool
Two types of start modes can be selected by setting the rotary switch on top of the main CPU
(HFil KM-Ml 11) (The rotary switch always returns to its original setting after the operation is completed,
so check the current setting to be sure it is correct.)
CPU rotary
switch
Start mode
Outline
Set the main CPU rotary switch to "B", and turn ON the CNC power.
B Normal mode
The maintenance tool menu screen will appear on the VDS. Select
the required tool from the menu and execute. The servo download
function can also be carried out in the normal mode.
Set the main CPU rotary switch to "9". Set the HR98x rotary switch
Automatic servo 1 to the number of the module to be downloaded, and turn ON the
9 F/W download CNC power. The selected module will be automatfcaiiy~
mode downloaded. Refer to the section titled 'Servo and spindle
downloading' for details.
* Supplement : When starting the maintenance tool by a CNC with personal computer,
the tool will not be started if the personal computer side is in a reset status.
3.2 Ending the tool
Turn OFF the CNC power when the operation is finished. The personal computer side is not started
even for a CNC with personal computer, so there is no problem if the CNC power is turned OFF in this
state.
After turning OFF the CNC power, remove the M6 Maintenance Tool cassette and any other cassettes
used in the maintenance. Return the main CPU rotary switch to the setting it was at before carrying out
the operation.
-4-