Table of Contents
Advertisement
46
en | Subsystem Maintenance
3.
Fig. 6.9 Drive Tray Key-Lock Rotation
4.
5.
6.
7.
Fig. 6.10 Installing a SATA Hard Drive
8.
CAUTION!
Only use screws supplied with the drive canisters. Longer screws may damage the drive.
9.
F.01U.027.797 | V1 | 2006.05
Remove the drive tray. To remove the drive tray from the enclosure, the key-lock must be
unlocked. (See Figure 6.9) To do this, turn the key-lock on the front of the drive tray until
the groove on its face is in a horizontal orientation.
Remove the drive tray along with the hard drive in it. Once the drive tray is dislodged
from the chassis, gently and carefully withdraw the drive tray from the chassis.
Remove the hard drive from the drive tray: Loosen the four retention screws (two on each
side) to remove the hard drive from the drive tray.
Install the new hard drive:
Place the SATA hard drive into the drive tray (as shown in Figure 6.10) making sure that
the hard drive is oriented in such a way that the drive's SATA connector is facing the back
of the drive tray.
Adjust the drive's location until the mounting holes in the drive canister are aligned with
those on the hard drive. Secure the drive with four supplied 6/32 flathead screws. (See
Figure 6.10)
If the failed drive is a member of a RAID 1, 3, or 5 array, once it is replaced the subsystem
should immediately start to rebuild the array. The drive activity LEDs should start to flash.
RAID Subsystem DVA-08K | Installation Manual
Bosch Security Systems
Advertisement
Table of Contents
