Connection For Pressure Measure / Regulation - Toshiba MITOS VT6 AIR User Manual

CONNECTION FOR PRESSURE MEASURE / REGULATION

The pressure measure/regulation must be performed using the connections of the following figure
It is recommended the use of filtered outputs to limit possible damages to the internal pressure sensor. These filtered
outputs thwart the dust or other elements to go up to the pressure sensor and to small elements to obstruct the flow into
the pipes. It is possible not to use the filtered outputs, but to the detriment of the instrument. The filtered outputs have to
be mounted directly on the filter, where there are usually the air outputs pipes. It is necessary to install a filtered output
for each pressure pipe, applied when necessary.
In the following image, you can see the particular of a filtered output.
02/10/2015 12 / 17 Manual_MITOS_VT6_AIR_ver3p3_eng