Table of Contents
Advertisement
-l
"I
~.
:· I
,/·1
·
::-
..
·:
"
(
r
·~-
i
]
·
1
J
J
·1
Model l l l 80A
Section
II
SECTION II
IN STALLATI 0 N
2-1. INTRODUCTION.
2-2. This section contains installation and shipping infor-
mation for the Model l l l 80A.
2-3. INITIAL INSPECTION.
2-4. Each l l l 80A has been carefully inspected prior to
shipment and should be in perfect electrical order and free
of mars or scratches. To confirm this, the instrument
should be inspected upon receipt for damage that might
have occurred in transit or for deficiencies otherwise.
If
there is damage due to shipping, file a claim with the
carrier; if there are electrical or mechanical deficiencies not
attributable to shipping, refer to the statement of warranty
on the cover page of this manual. Use the procedures of
Section
V
to check the instrument performance. Refer to
Section I for the list of equipment supplied with the
instrument.
2-5. INSTALLATION OF 11180A INTO 3480A/B.
IMPORTANT
2-6.
Contact your local Hewlett-Packard Sales and Service
Office regarding installation of the 11l80A into an existing
3480A/B. (See Appendix B for office locations.)
2-7. STORAGE CONNECTOR.
2-8. See Table 3-1 for
the signal arrangement at the
Storage Connector.
2-9. REPACKAGING FOR SHIPMENT.
2-10.
If
the instrument is to be shipped to Hewlett-Packard
for service or repair, attach a tag to the instrument
describing the work to be accomplished and identifying the
owner and
instrument.
Identify the instrument by serial
number, model number and name in any correspondence.
If
you have any questions, contact your local Hewlett-Packard
Sales and Service Office. See Appendix
B
for office
locations.
2-11.
If
the original shipping container is to be used, place
the instrument in the container with appropriate packing
meterial and seal the container well with strong tape or
metal bands. A new container may be purchased from your
nearest -hp- Sales and Service Office.
2-12.
If
an -hp- container is not to be used, then use a
heavy carton or wooden box with an inner container. Wrap
the instrument with heavy paper or plastic and place
cardboard strips across the face for protection before
placing the instrument in the inner container. Use packing
material around all sides of the inner container, and seal the
outer container well with strong tape or metal
bands.
Mark
the container with "DELICATE INSTRUMENT," or
"FRAGILE".
2-1
Advertisement
Table of Contents
