Installation - Kenwood KDS-100 Service Manual

TK-760G/762G/860G/862G/768G/868G Series
(TK- 60G Series)
*
■ Installing the KCT-35 in the Transceiver
1. Remove the upper cover from the transceiver.
2. Lift the DC cord bushing (
3. Remove the pad as shown in the Figure 3 (
4. Insert the KCT-35 cable (
wire harness band ( ) must be inside the chassis.
5
5. Replace the DC cord bushing (
6. Connect the KCT-35 to the TX-RX unit (A/2) as shown in
Figure 4 ( ).
7
Connector Wire Color Pin No.
A-1 Brown 4
A-2 Green 7
A-3 NC –
A-4 Orange 5
A-5 NC –
A-6 NC –
A-7 Yellow 6
A-8 Blue 8
1
2
Fig. 3
A
CN5
B
CN4
CN3
C
7
INSTALLATION / REALIGNMENT
) from the chassis.
1
).
2
) into the chassis ( ). The
3 4
).
6
Connector Wire Color Pin No.
B-1 Gray 10
B-2 White 11
B-3 Purple 9
C-1 NC –
C-2 Black 3
C-3 Red 1
A
B
C
5
4
3
KCT-35
6
13
15
Fig. 4
Transceiver Setting
When the KDS-100 (Mobile Data Terminal) is connected
to a transceiver, the transceiver functions must be set. The
transceiver FPU is used to make this setting.
For a connection method, see Figure 1.
■ TK- 80 Series Setting Method
*
1. Setting with KPG-49D (K and M markets FPU)
1) Select "Optional Features" from the "Edit" menu and
set COM1 (Internal Port) "[None]" to "[Data]".
2) Select "FleetSync" from "Edit" and set functions to
"Yes/No" as follows:
Status Message Stack ................... [No]
Short Message Stack ..................... [No]
Caller ID Stack ................................ [No]
Status Message Serial Output ....... [Yes]
Short Message Serial Output ........ [Yes]
3) Enter an ID.
Fleet (Own): A three-digit number between 100 and 300
can be entered in [
ID (Own): A four-digit number between 1000 and 4999
can be entered in [
2. Setting with KPG-60D (E markets FPU)
1) Select "Extended Function" from the "Edit" menu and
set COM1 " None " to " Data ".
2) Select "Digital Message System" from "Edit" and set
the checkboxes as follows:
• Uncheck items.
Status Message Stack
Short Message Stack
Selcall ID Stack
• Check items (✓).
Status Message Serial Output
✓
Short Message Serial Output
✓
3) Enter an ID.
Fleet (Own): A three-digit number between 100 and 300
can be entered in
ID (Own): A four-digit number between 1000 and 4999
can be entered in
KDS-100 or
1
through KCT-36
3
extension cable.
KDS-100
].
].
.
.
3