Configure 802.11a/b/g/n (Wi-Fi) Radio Communications
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.
The computer contains an 802.11 radio to transfer data using wireless communications
and to support the TCP/IP network protocols. This section of the manual assumes that
your wireless network is set up, including your access points.
By default, the 802.11 radio is enabled. If it is disabled, use the following procedure to
enable the Wi-Fi radio using Intermec Settings.
1. From the Intermec Settings main menu, tap Communications > 802.11 Radio >
2. Select the Radio Enabled check box and tap OK. By default, the computer uses
3. Use Intermec Settings to configure any other parameters you need to use for
4. Configure 802.11 security. For help, see
About Bluetooth Communications
Your computer is Bluetooth™-enabled out-of-the-box. With Bluetooth, you can connect
to other Bluetooth devices, such as scanners or printers.
Connect to a Bluetooth Scanner
You can connect the computer to a Honeywell Bluetooth scanner, such as the SF51 or
SR61.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide
Radio Enabled.
Wireless security and enables DHCP.
communication with your network.
About Wireless
Security.
43