Procedures For Installation And Setting - Mitsubishi Electric MES3-255C-EN User Manual

4. Procedures for Installation and Setting

 Installation
The following explains the operations from package opening to installation.
(1) Open the package.
(2) Check the packaged contents.
(See "Packaged contents" on page 1 of this instruction manual.)
(3) Insert the supplied memory card into the memory card slot.
(4) Connect the battery mounting connector.
(See "6.1 Installing battery" of this instruction manual.)
(5) Check that the CC-Link station number setup switch is set to "0".
(See "CC-Link station number setup switch" in "3. Name and Function of Each Part" of this instruction manual.)
(6) Set a communication speed using the CC-Link communication speed setup switch.
(See "CC-Link communication speed setup switch" in "3. Name and Function of Each Part" of this instruction
manual.)
(7) Install this product.
(See "5. Main Unit Installation" of this instruction manual.)
(8) Conduct wiring.
(See "8. Connection Diagram" of this instruction manual.)
(9) Check wiring conducted in step (8).
This completes the installation procedure.
Read "Precautions concerning the installation" carefully to perform the operation safely.
Caution
If the product gives off abnormal noise, smell, smoke or heat, turn the power off immediately.
 Setting
The following explains the preparation for operating the product after it is installed.
(1) Use the supplied CD to install the setting software on your PC.
(See " 2.3 Installation of the software " in User's Manual – Setting.)
(2) Use the configuration software to set an IP address for the product.
(See "7. IP Address Setting" of this instruction manual.)
* When you use the factory default setting (192.168.10.1 for IP address), you do not have to perform this step.
(3) Use the configuration software to set a date and clock for the product.
(See Instruction Manual–Setting.)
(4) Configure client computers to your network environment.
For details on settings, contact your network administrator.
For details on setting procedures, see the instruction manual of your computer or contact its manufacturer.
(5) Configure the web browsers in the client computers.
(See Instruction Manual– Operation.)
(6) Set necessary information such as connected devices and measuring points.
(See Instruction Manual–Setting.)
(7) Check the product operation.
(See Instruction Manual– Operation and Setting.)
Wrong network settings may cause other devices on the network to malfunction.
The factory settings for this product are as follows: 192.168.10.1 for the IP address,
Caution
255.255.255.0 for the subnet mask, and no gateway setting.
When you connect the product directly to a single PC, you do not have to change these
settings.
13