Common procedure
This section describe pre- or post-execute or common procedure for some
license apply commands actually.
(1)Connect to the management module
First of all, connect to the management module by telnet and so on, and login
with a user ID and password with administrator (admin) privilege.
The user ID and the password of management modules shipped from the
factory are set as below.
login: administrator
Password:
xxxxx
BladeSymphony BS2000 Management Module
ALL RIGHTS RESERVED, COPYRIGHT (C), 2008, 2012, HITACHI, LTD.
Chassis ID
Firmware Revision : xxxx-x-xxxx
<< System Console Main Menu >>
P. Start OS console session.
SW. Start switch module console session.
S. System command mode.
X. Exit.
(P,SW,S,X) :
login: administrator
Password:
xxxxx
BladeSymphony BS500 Management Module
ALL RIGHTS RESERVED, COPYRIGHT (C), 2011, 2012, HITACHI, LTD.
Chassis ID
Firmware Revision : xxxx-xxxx
(0)$
2-6
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Item
user ID
password
Enter User ID of administrator (admin).
Enter Password of administrator (admin).
:
Compute Blade 2000
Enter User ID of administrator (admin).
Enter Password of administrator (admin).
:
Compute Blade 500
Factory settings
administrator
password
Preparations