Hitachi Compute Blade 500 Installation Manual page 42

Check Compute Blade Status
Chapter 3 shows the requirements to perform the procedure in this chapter. If
the configuration, the status of the Compute Blade and DCB Switches meet the
requirements, go to Section 2 "Install the License."
Otherwise, follow the steps shown in Section 1 "Check the System Status" of
Chapter 3 and activate the DCB Switch.
Install the License
Access to the DCB switch module as per the procedure described in Common
(1)
procedure.
Execute license add licstr command to install the license key.
(2)
The syntax of the command is as follows:
sw0#
license add licStr
igaR7wF43d81Rj4p0nqFL2YbkOOWagO5NoL8PM:SXmf3lgQfT8HEB92qlRStO5c0LbXt4B
QAFJXA,bv7w6,gVAf2S2kQzHKllpjD7vYiz6wTV1#"
License Added [*B
igaR7wF43d81Rj4p0nqFL2YbkOOWagO5NoL8PM:SXmf3lgQfT8HEB92qlRStO5c0LbX
t4BQAFJXA,bv7w6,gVAf2S2kQzHKllpjD7vYiz6wTV1#]
Compute Blade 2000 / Compute Blade 500 / Compute Blade 2500
Confirm that the license is installed by show license command.
(3)
sw0#
show license
Switch id: 10
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Obtain the license add licstr command and show license command log
containing the DCB Switch configuration information, and save it in a safety
device such as a removable media.
6-2
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
"*B
Enter show license command.
VCS Fabric license
Feature name:VCS_FABRIC
Install the License
 Enter license add command.
License Key. Enter the license key
you got in Section 3 "Obtain the
License Key" in Chapter 5.
Indicates that the specified
license is installed.