Kenwood K10W7D18 Installation Instructions Manual page 26

There's not much foam.
There's a lot of foam.
Fabric softener overflows.
There's a residue of
powder detergent at the
end of the wash.
There's a noise when the
water drains away.
The electricity supply cuts
out while the machine is
on.
The water supply is
disrupted.
26
• This can happen if you've put powder detergent directly into the
drum – you must put it in the detergent drawer.
• The amount of foam can vary, depending on the temperature,
level and softness of your water.
• You may not be using enough detergent.
• You may be using a reduced-foam type of detergent.
• Heavily soiled laundry can reduce the amount of foam.
• Larger loads of laundry can also reduce the amount of foam.
• The amount of foam can vary depending on the temperature, level
and softness of your water.
• You may have used too much detergent.
• The type of detergent you use could cause excess foam.
• You may have exceeded the MAX level in the softener drawer.
• You may have spilt the liquid by closing the softener drawer too
sharply.
This can happen if you've put powder detergent directly into the
drum – you must put it in the detergent drawer.
This is normal, it's the pump starting and stopping.
The machine will stop (do not open the door if the machine is full of
water). When the power comes back on, the machine will continue
the programme.
When the water comes back on, it may be impure at first.
You'll need to disconnect the water-supply hose and drain any
impure water through the tap before using your machine again.
Remember to re-connect the water supply hose first.