Diagnostic Leds - Bosch B6512 Installation Manual

Control Panels
Caution!
Remove all power (AC and battery) before making any connections. Failure to do so might
!
result in personal injury and/or equipment damage.
Inserting the cellular module
1.
2.
Installing the module
1.
2.
3.
Wiring the antenna
1.
2.
3.
Wiring to the control panel
Use either the terminal strip labeled with PWR, A, B, and COM on the module to wire to the
SDI2 terminals labeled on the control panel, or use the interconnect wiring connector and the
included interconnect cable.
For terminal wiring, use 18 AWG to 22 AWG (1.0 mm to 0.6 mm) wire.
Notice!
Use either the terminal strip wiring or interconnect wiring to the control panel. Do not use
both. When you connect multiple modules, you can combine terminal strip and interconnect
wiring connectors in parallel.
3
8.4.4

Diagnostic LEDs

The module includes the following on-board LEDs to assist with troubleshooting:
–
–
–
The plug-in module also includes LEDs for troubleshooting and status.
Bosch Security Systems, Inc.
Install a SIM card, if required by the cellular module.
Push the plug-in cellular module into the B450 until you hear the module "click" into
position.
Set the module address.
Hold the module mounting brackets onto the inside of the enclosure. Match the bracket
holes to a 3-hole mounting pattern on the enclosure
Use the supplied mounting screws to secure the module.
Secure the antenna cable to the outside of the enclosure.
Route the antenna cable through a wire knockout in the top of the enclosure.
Connect the antenna cable to the cellular module.
SDI2 ON-BOARD POINTS
Device Bus
1
Voltage Ranges
R Y G B
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
AUX
1 COM 2 3 COM 4 5 COM 6
- 12 V +
COM AUX R Y G B 1 COM 2 3 COM 4 5 COM
PWR A B COM
2
R
Y
G
B
Heartbeat (system status)
RX (receive)
TX (transmit)
C
OUTPUT
B
7 COM 8
6 7 COM 8
2
R
R
Y
Y
G
G
B
B
Installation Manual
IP communications | en
SDI2
ON-BOARD POINTS
Device Bus
1
Voltage Ranges
R Y G B
Open 3.7 - 5.0 VDC
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
1 k End of Line Resistors
AUX
1 COM 2 3 COM 4 5 COM 6
- 12 V +
COM AUX R Y G B 1 COM 2 3 COM 4 5 COM
PWR A B COM
4
2018.07 | 16 | F.01U.287.180
39
C
OUTPUT
B
7 COM 8
6 7 COM 8