Hitachi HA8000 Series User Manual page 16

16
Click [OK]
8 For the device whose device driver has not been updated, repeat steps 2 to 7. Check that "Intel®
PRO/1000 PT Dual Port Server Adapter" appears by the number of installed Cards under [Network
adapters].
9 When all adapter finished to update and remove LAN driver, Click [Action] of [Scan for hardware
change]. (It automatically will update LAN driver.)
10 Check the value of the IP address. The initial value of the IP address is "Obtain an IP address
automatically". If the IP address of a fixed value is to be used, it is necessary to change the IP
address setting. After changing the IP address setting, check that the LAN cable is connected to its
destination such as a hub and then restart the system unit.
When the driver is set up, the message "This device cannot start.
(Code10)" may appear. Restart the system unit and the driver will operate
normally. Check that the device operates normally referring to [Device
Manager].
Restrictions to change parameters of the network adapter
After changing the network adapter setting, transmission may not be
made normally with the changed adapter. Check the changed network
adapter in the Device Manager window. If "!" is displayed, right-click the
adapter and disable it. Then enable the adapter again. The adapter
becomes available.