Installation Instructions
Model ADB-11
Audible Base
INTRODUCTION
Model ADB-11
The Model ADB-11Audible Base consists of a standard Series 11 base
combined with an audible device. The ADB-11 is an audible base used only with
Series 11 conventional detectors (DT-11, PE-11/-11T) and is powered directly
from the zone circuit. (Refer to Table 1 for compatible detector model numbers
and the related Installation Instructions.) All field wiring terminates at a four
position terminal block located on the back of the unit. The audible device
sounds when the detector alarms and stops sounding when the system is
reset. (Refer to Figure 1, the ADB-11 Audible Base Terminal Blocks, and
Figure 2, the ADB-11 Wiring Diagram.) Only one device is guaranteed to
activate per zone.
The ADB-11 can generate either steady or temporal tone with the insertion of a
jumper at the terminal block.
AUX
NOT USED
JUMPER FOR
TONE SELECTION
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
P/N 315-096162-8
+
5
_
6
7
8
ADB-11 Audible Base Terminal Blocks
4
3
ADB-11
2
1
FROM INITIATING CIRCUIT OF
COMPATIBLE CONTROL PANEL
Figure 1
Siemens Building Technologies, Ltd.
Fire Safety & Security Products
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 Canada
TO NEXT DB-11 OR ADB-11
_
+
_
+