GE ADTS542F User Manual page 77

ADTS542F/552F/553F/554F User Manual
Optimum pairing procedure
The following procedure is used to "Pair" the base unit and ADTS Touch:
1. Place the ADTS Touch on (but not docked) or close to the base unit.
2. Power cycle the base unit and ADTS Touch.
3. On the ADTS Touch, select "TOOLS". The "TOOLS" menu opens.
4. From the "TOOLS" menu, select "BLUETOOTH". The "BLUETOOTH" menu opens.
5. Select "SCAN FOR NEW DEVICES". The message "Please wait scanning for devices" is displayed.
A list of available devices is displayed showing the MAC address and serial numbers of the
devices.
6. If necessary, scroll down the list and select (highlight) the desired base unit serial number from
the list.
7. Touch the "tick" icon to confirm the selection and close the list of devices. The base unit and
ADTS Touch are now "Paired".
8. Touching the "cross" icon closes the list of devices without making any changes.
If the Bluetooth® link drops and does not automatically reconnect, then repeat the procedure
above rather than pairing the devices from within the cockpit.
K0553 Revision C
F 3-34 B
IGURE LUETOOTH
® R C
ELIABLE OVERAGE
A
REA
3-43