Parts; Parts Order - Pioneer PT Series Operation & Maintenance Manual

PARTS ORDER

When ordering parts from Pioneer Pump, Inc. please provide the following information:
1) Pump serial number
2) Pump model
3) Cross section drawing number
4) Part number from cross section drawing (or part name if no number is noted)
5) Description of part
6) Quantity required
7) Package VIN (Vehicle Identification Number for skid or trailer mounted units)
SPARE PARTS
Spare parts should be kept on hand to reduce downtime. At a minimum the following parts
should be stocked.
Wear Plate
All O-rings
Set of bearings
Mechanical seal
Set of grease seals
If you have unusual pumping conditions, consult Pioneer Pump, Inc. for additional
recommended spare parts.
Pumps are adequately prepared for outside storage prior to shipment, but use the following list
of additional suggestions for extended storage.
1) Store the unit off the ground so no water will accumulate around the equipment.
2) Protect unit from blowing sand and dirt.
3) Stack no other items on top of pump/equipment.
4) Protect unit from the entry of any animals.
5) Periodically rotate shaft to lubricate bearings and protect bearings from brinelling.
6) Protect unit with approved drying agents.
7) Ensure all bare metal areas are coated with rust preventative.
8) Inspect unit every four (4) weeks and replace drying agents (Silica Gel) as required or a
minimum of ever six (6) months.
9) Keep an inspection record showing dates of inspection with any maintenance preformed
and condition of drying agents.
10) Before installation ensure that all rust protection has been removed. Also, remove any
foreign material that may have accumulated during storage.
11) Before installation remove all drying agents (Silica Gel).
STORAGE
19