Security Section; Supervisor Password - LG E-NOTE H1000B User Manual

Set User Password
Set User Password allows you to set a password that is lower than Set Supervisor
Password. To set a user password, a supervisor password must be set.
Main Advanced
Phoenix SecureCore(tm) Setup Utility
Supervisor Password Is:
Main Advanced
Set Supervisor Password
Supervisor Password Is:
User Password Is:
Set Supervisor Password
User Password Is:
Set User Password
Set User Password
Password on boot:
Password on boot:
F1 Help Select Item
ESC Exit Select Menu
F1 Help Select Item
ESC Exit Select Menu
Note
● There are more restrictions for using CMOS setup with user password than with

supervisor password.

Caution
● HDD password is required for protection of privacy and data. ● If you forgot your
password, you cannot use the system. Write the password down and keep it in a
safe place.
24
Phoenix SecureCore(tm) Setup Utility
Security Boot
Clear
Security Boot Exit
[ Enter ]
Item Specific Help
Clear
Clear
[ Enter ]
Supervisor Password
Clear
[ Enter ]
controls access to the
[ Enter ]
[Disabled] setup utility.
[Disabled]
-/+ Change Values F9 Setup Defaults
Enter Select Sub-Menu F10 Save and Exit
-/+ Change Values
Enter Select
Exit
1. Activate the system setup window and
Item Specific Help
use the arrow keys to move to the
Supervisor Password

Security section.

controls access to the
2. In the window shown on the left, use
setup utility.
the arrow keys to select [Set User
Password] and press the [Enter] key.
3. When the message shown on the left
appears, enter a password and press
F9 Setup Defaults
Sub-Menu F10 Save and Exit
the [Enter] key. The password can be
up to 8 alphanumeric characters (A - Z,
0 - 9).
4. When the message shown on the left
appears, press the [Enter] key.
5. Press the [F10] key to save the
changes.
6. When the message shown on the left
appears, select [Yes] and press the
[Enter] key. Then, the product restarts.