Programming for Initial Setup
After power is supplied to the Base Unit, a setup sequence will enable customization of the
system.
SEVEN EASY STEPS:
1. Choosing a Language
2. Set Time and Date
3. Set Master Code
4. Assign Devices (have Key Chain Remote, sensors and batteries ready)
5. Test Range
6. Add Users
7. Monitoring Service
STEP ONE: CHOOSING A LANGUAGE
Choose from three different languages: English, French or Spanish.
A language will be displayed on the screen when power is supplied to the Base Unit.
1. To continue in English, select OK.
2. To choose another language, use the arrow keys to find the correct language.
3. When the desired language is displayed, select OK.
STEP TWO: SET TIME AND DATE
Time and date MUST be set during the initial setup. The event log will list all events accord-
ing to date and time.
1. Using the numbers on the keypad, set the clock to the appropriate time, changing
hours first, then minutes. The character that is being changed will be underlined. To
move back a character, use the down arrow. To move forward a character, use the up
arrow. Select SET.
2. Choose AM or PM. The up and down arrows are used to toggle between AM and PM.
Select SET.
3. Using the numbers on the keypad, set the date. The character that is being changed
will be underlined. To move back a character, use the down arrow. To move forward a
character, use the up arrow. Select SET
STEP THREE: SET MASTER CODE
A master code MUST be selected. This code can be changed; however, it is the ONLY
code that can be used to make programming changes and clear a fault.
The Enter Master Code screen will appear after the date is set.
1. Using the numbers on the keypad, enter a four digit master code. The character that
is being changed will be underlined. To move back a character, use the down arrow.
To move forward a character, use the up arrow.
NOTE: Only the master code can be used to make programming changes. Be sure
to choose a code that is easy to remember or write this code in a secure location away
from the system. If you lose this code, you will need to have it reset through customer
service. See If You Lose Your Code for details. All other users will have access to
the arming and disarming features only. To add a new user see Add Users.
2. After entering the master code, select OK.
3. Re-enter the master code to confirm. Again, using the numbers on the keypad, enter
the four digit master code. Select OK.
4. If the master codes match, the screen will indicate that the master code has been
saved. Select NEXT.
NOTE: If the codes do not match, the screen will display Code Incorrect.
If Master Codes Do Not Match
1. Select OK.
4