Features & Options; System Settings; Wireless Device Maintenance; Change Master Code - DeWalt DS100 Instruction Manual

DESCRIPTION OF FAULT CODES
NOTE: See the Troubleshooting Guide for more detailed information.
DESCRIPTION OF FAULT CODES
Fault Code Fault Display
Power Primary Power
Lost Base
DevPower Primary Power Lost
Device #
BaseLowBatt Base
Low Battery
DevLowBatt Low Battery
Device #
WeakSig Weak Signal
Device #
Unsecured Unsecured
Device #
NoCheckIn No Check In
Device #
Tamper Tamper
BaseBadBatt Bad Battery
Base
CellRadio Cell Radio
Fault
Receiver Receiver Fault
Device #
FEATURES & OPTIONS

System Settings

The systems settings menu allows for changes in user codes, wireless devices, automatic
arming, delays and account information.

• Wireless Device Maintenance

• Change Master Code

• User Code Maintenance

• Set Console Devices

• Set Delay/Instant

WIRELESS DEVICE MAINTENANCE
After the initial setup, a device such as a sensor or Key Chain Remote can be added,
edited or removed.
• Adding or Replacing a Device
• Editing a Device
• Removing a Device
Description Action
No power to Check power supply
Base Unit
No battery power Change battery, reset
in device
Base Unit Plug in power supply
battery low to recharge battery
Device battery Change battery, reset
low
Transmission signal Check for interference;
from device is weak move device
Device has Check for intrusion;
been tripped re-secure device
Device check-in Check for interference;
messages have not move device
been received
Device has been Close device or
opened or damaged replace if damaged
Base Unit battery has Needs to be repaired
dropped below the at D WALT authorized
E
voltage limit service center
Cellular radio Move Base Unit to
signal is lost a location where
CELL light is solid
2-way transmission Call customer service
of device is lost to test system for issues

• Clear Settings

• Auto Arm ON/OFF

• Auto Arm Time Set

• Review Account

• Choose Language
1. Start at the main screen.
2. Select MENU or press MAIN MENU on the keypad.
3. Using the keypad, enter the master code.
4. Use the up and down arrows to scroll through the menu until the System Settings
screen is displayed. Select OK.
5. Use the up and down arrows to scroll through the menu until the Wireless Device
Maintenance screen is displayed. Select OK.
To Add a Device:
1. Use the up and down arrows to scroll through the menu until the Add/Replace Device
screen is displayed. Select OK.
2. The next available device number will be displayed. If there are no slots available, the
screen will display ALL DEVICES IN USE.
To replace a device, use the up and down arrows to select the device to be replaced.
If a previously programmed device is selected, the old device will be overwritten when
the reset button on the new device is pressed.
3. When the device number is shown, select OK. The device will not register until after
the OK button is pressed and device has been reset.
4. Reset the device.
10