Table of Contents
Advertisement
Drawing
Symptom
The drawn line is thicker
(thinner) than intended.
The machine stopped
while an operation is
being performed.
Scanning
Symptom
Unwanted images are
scanned.
Scanning cannot be
done cleanly (there are
lines in the scanned
image).
The lines printed on the
mat are scanned.
The scanned image is
red.
The scan image is out of
focus.
98
Possible Causes (or Results)
The drawing speed ("Draw Speed")
or drawing pressure ("Draw
Pressure") is incorrect.
For safety, the machine stops
operating if the panel is touched
while drawing.
Possible Causes (or Results)
The scanning area is incorrectly
specified.
The scanner glass is dirty.
The original to be scanned is dirty
or scratched.
The original is transparent so the
lines printed on the mat are being
scanned.
When the optional scanning mat is
used, scanning is performed
without peeling off the blue tape.
The scanner lever is not correctly
positioned for the thickness of the
material
Solutions
Adjust the settings for "Draw Speed" and
"Draw Pressure" in the settings screen.
To draw thicker lines, increase the
drawing pressure. To draw thinner lines,
decrease the drawing pressure.
To draw thicker lines, reduce the drawing
speed. To draw thinner lines, increase
the drawing speed.
After adjusting the settings, perform a
test/trial drawing operation.
Follow the instructions in the message
that appears in the screen. Touch the
"OK" key to move the carriage to its
initial position. Load the mat and perform
the operation again.
Solutions
In "Scan to USB" mode, specify the
paper size with the "Scan Size" setting.
In "Direct Cut" or "Scan to Cut Data"
mode, trim the image in the editing
screen after scanning.
Clean the scanner glass inside the
machine.
In "Direct Cut" or "Scan to Cut Data"
mode, remove thin lines or dirt in the
image editing screen.
In "Direct Cut" or "Scan to Cut Data"
mode, remove the lines in the image
editing screen.
Peel off the blue tape from the optional
scanning mat before scanning.
Set the scanner lever position to "1".
Reference
page 10
page 62
—
Reference
page 83
page 71
page 77
page 91
page 81
page 81
—
page 9
Advertisement
Table of Contents
