Table of Contents
Advertisement
Blade and Material Combination
The appropriate blade differs depending on the material type and thickness. Before cutting the material, be sure
to perform test cut (trial cut). For details on trial cutting, see "Test Cut (Trial Cut)" on page 25.
Use the following table to select the appropriate cutting blade according to the material that will be cut.
Material compability may vary. Always perform a test/trial cut to confirm a successful cut.
If you need additional help, the Brother Solutions Center offers the latest FAQs and troubleshooting tips.
Visit us at " http://s.brother/cpoac/ ".
Material
Printer paper
Scrapbook paper
Cardstock
Vellum, tracing paper
Poster board
Thin cotton fabric (for quilt piece)
Thin cotton fabric (except for quilt
piece)
Flannel (for quilt piece)
Flannel (except for quilt piece)
Felt
Denim 14 oz
Plastic sheet (PP)
Vinyl
Adhesive Craft Vinyl (backing sheet
: 0.1 mm)
Magnet
Sticker or seal
Sticker Sheet (backing sheet :
0.15 mm)
Foam sheet
• Use a high tack adhesive fabric support sheet or a iron-on fabric appliqué contact sheet when you cut a piece of
fabric out. For details, see "Reference Table of Mat and Material Combinations" on page 14.
• Depending on the model, the thin fabric auto blade may not be included. In that case, it can be purchased as an
optional accessory.
Note
• An auto blade holder is included with this machine. With this blade holder, the thickness of the material is
detected, and the blade extension is automatically adjusted.
• Thick or hard material will automatically be cut multiple times.
Thickness
Auto Blade (Black)
80 g/m² (0.1 mm)
200 g/m²
(0.25 mm)
280 g/m²
(0.35 mm)
0.07 mm
400 g/m²
(0.5 mm)
0.25 mm
0.25 mm
0.5 mm
0.5 mm
3 mm
0.75 mm
0.2 mm
0.2 mm
0.07 mm
0.3 mm
0.2 mm
0.15 mm
3 mm
Auto blade holder
Thin Fabric Auto Blade
(Beige)
2
23
Advertisement
Table of Contents
