Reference Table Of Mat, Blade And Material Combinations - Brother SDX325 Operation Manual

Reference Table of Mat, Blade and Material Combinations

Use a mat and blade appropriate for the material, as referred to in this table. You can also check the latest
reference table at http://s.brother/cfokb/.
Before using materials from your project, test attaching the material to check the adhesion to the mat.
The optimal blade type will vary depending on the type or thickness of the material. Perform a test cut before
cutting the material. For test cutting, refer to "Test Cut (Trial Cut)" on page 27. Depending on the material, the
appropriate combination may differ from the table below. Always perform a test cut to be sure the material can
be cut without a problem.
If a problem cannot be resolved, check the Q&A on the Brother support website (http://s.brother/cpoac/).
Note
• The blade holder included with this machine is an auto blade holder. It detects the thickness of the material and
automatically adjusts the blade length.
• Thick or hard materials are automatically cut multiple times.
■ Paper and Other Materials
Material
Printer paper 80 g/m² (0.1 mm)
Scrapbook paper
(thin)
Scrapbook paper
(medium-thick)
Cardstock
Vellum, tracing paper
Poster board
Plastic sheet (PP)
Vinyl
Magnet
Sticker or seal
Foam sheet

* When cutting paper with a smooth surface
Mat (for ScanNCut DX)
Thickness
Standard Tack
Adhesive Mat

120 g/m²
(0.15 mm)
200 g/m²

(0.25 mm)
280 g/m²

(0.35 mm)
0.07 mm
400 g/m²

(0.5 mm)

0.2 mm

0.2 mm

0.3 mm

0.2 mm

3 mm
Auto Blade Holder (Blade)
Low Tack
Auto Blade (Black)
Adhesive Mat






*


*










2
Vinyl Auto Blade
(Blue)

15