Brother SDX325 Operation Manual page 115

Drawing
Symptom
The drawn line is thicker
(thinner) than intended.
The machine stopped
while an operation is
being performed.
Scanning
Symptom
Unwanted images are
scanned.
Scanning cannot be
done cleanly (there are
lines in the scanned
image).
The lines printed on the
mat are scanned.
The scanned image is
red.
The scan image is out of
focus.
Data Transfer
Symptom
The data retrieved with
the machine is different
from the transferred
data.
Transferred data cannot
be retrieved.
112
Possible Causes (or Results)
The drawing speed ("Draw Speed")
or drawing pressure ("Draw
Pressure") is incorrect.
For safety, the machine stops
operating if the panel is touched
while drawing.
Possible Causes (or Results)
The scanning area is incorrectly
specified.
The scanner glass is dirty.
The original to be scanned is dirty
or scratched.
The original is transparent so the
lines printed on the mat are being
scanned.
When the optional scanning mat is
used, scanning is performed
without peeling off the blue tape.
The scanner lever is not correctly
positioned for the thickness of the
material
Possible Causes (or Results)
Multiple data items are being
transferred from
CanvasWorkspace or from a
machine using the "My
Connection" function.
The storage period on the server
has elapsed.
The cutting machine was not
registered on CanvasWorkspace at
the time the data was transferred
from the embroidery machine using
the "My Connection" function.
Solutions
Adjust the settings for "Draw Speed" and
"Draw Pressure" in the settings screen.
To draw thicker lines, increase the
drawing pressure. To draw thinner lines,
decrease the drawing pressure.
To draw thicker lines, reduce the drawing
speed. To draw thinner lines, increase
the drawing speed.
After adjusting the settings, perform a
test/trial drawing operation.
Follow the instructions in the message
that appears in the screen. Touch the
"OK" key to move the carriage to its
initial position. Load the mat and perform
the operation again.
Solutions
In "Scan to USB" mode, specify the
paper size with the "Scan Size" setting.
In "Direct Cut" or "Scan to Cut Data"
mode, trim the image in the editing
screen after scanning.
Clean the scanner glass inside the
machine.
In "Direct Cut" or "Scan to Cut Data"
mode, remove thin lines or dirt in the
image editing screen.
In "Direct Cut" or "Scan to Cut Data"
mode, remove the lines in the image
editing screen.
Peel off the blue tape from the optional
scanning mat before scanning.
Set the scanner lever position to "1".
Solutions
Only a single file of data can be
transferred over the server. If data is
repeatedly transferred before retrieving it
with the cutting machine, it is updated to
the latest data.
Data is erased from the server after a
certain period of time has elapsed since
the data was transferred. Retrieve the
data on the machine as soon as possible
after transferring the data.
Register the cutting machine with
CanvasWorkspace machine registration,
and transfer the data from the
embroidery machine again.
Reference
page 10
page 57
—
Reference
page 81
page 67
page 73
page 105
page 79
page 79
—
page 9
Reference
—
—
page 89