Brother SDX325 Operation Manual page 113

Symptom
When the mat is
inserted, the attached
material peels off.
Paper/Fabric Jam
Symptom
The mat cannot be fed.
The mat or the material
catches on a feed roller
when the mat is being
inserted.
The mat or the material
catches on a feed roller
during cutting/drawing/
scanning.
The mat is fed in at an
angle and is not fed
during cutting/drawing/
scanning.
The material to be cut/
drawn or original to be
scanned peels off during
cutting/drawing/
scanning.
Cutting
Symptom
The material being cut
catches on the tip of the
cutting blade.
The machine stopped
while an operation is
being performed.
110
Possible Causes (or Results)
The mat is not level due to the
weight of the material.
The mat's adhesive strength has
decreased.
Possible Causes (or Results)
There is an obstruction around the
slot at the back of the machine.
The surface where the machine is
installed is uneven.
The mat's adhesive strength has
decreased, or the material is not
secured.
The material or tape is extending
from the adhesive surface.
The thickness of the material
exceeds the maximum limit.
- The mat's adhesive strength has
decreased, or the material is not
secured.
- The material extends from the
adhesive area of the mat.
- The rear tray is not pulled out.
Possible Causes (or Results)
Dust or lint has accumulated in the
holder.
The blade is worn.
The material being cut is
incompatible with this machine.
For safety, the machine stops
operating if the panel is touched
while cutting.
Solutions
With your hands, hold the mat level when
inserting it.
Replace the mat with a new one.
Solutions
Maintain space around the slot at the
back of the machine so that the mat can
be fed out.
Place the machine on a flat, even
surface.
Press the "Feed" button to feed out the
mat, and then replace the mat with a new
one.
After pressing the feed button and
removing the mat, attach the material or
tape so that it fits on the adhesive
surface of the mat.
Press the "Feed" button to feed out the
mat, raise the scanner lever, and then
correctly insert the mat.
Press the "Feed" button to feed out the
mat, and then change the material to a
thin one.
Press the "Pause/Stop" button to stop
the operation. Follow the instructions on
the screen, and press the "Feed" button
to feed out the mat.
If the mat does not feed out, turn off the
machine, remove the holder, and then
manually feed out the mat.
After feeding out the mat, replace it with
a new one or attach the material while
keeping it within the adhesive area of the
mat. Pull out the rear tray, and then
insert the mat.
Solutions
Clean the holder.
Replace the blade with a new one.
Replace the material with one
compatible with this machine.
Follow the instructions in the message
that appears in the screen. Touch the
"OK" key to move the carriage to its
initial position. Load the mat and perform
the operation again.
Reference
page 28
page 101
Reference
page 8
—
page 29
page 101
page 18
page 29
page 7
page 9
page 29
—
page 7
page 9
page 18
page 29
page 101
Reference
page 103
page 101
page 15
—