Removing The High Voltage Power Supply Pcb - Canon MF8580Cdw Service Manual

4
Disassembly/Assembly > Controller System > Removing the High Voltage Power Supply PCB > Procedure
10) Free the Power Supply Harness [1] by putting it through the hole [A] of the plate.
• 1 Connector [2]
11) Remove the Low Voltage Power Supply Unit [3].
• 1 Connector [4]
x2
[4]
[3]
4 Disassembly/Assembly > Controller System > Removing the High Voltage Power Supply PCB > Procedure
[1]
[A]
[2]
F-4-432

Removing the High Voltage Power Supply PCB

■ Preparation
1) Remove the Right Cover. Refer to page 4-147.
2) Remove the Left Cover. Refer to page 4-144.
3) Remove the Rear Upper Cover. Refer to page 4-153.
4) Remove the ADF Unit/Copyboard + Reader Unit. Refer to page 4-158
5) Remove the Upper Cover.Refer to page 4-156
■ Procedure
1) Disconnect the flat cable [1].
• 1 guide [2]
x2
4-193
[2]
[1] [2]
F-4-433
4-193