Safety And Servicing Information; Rf Exposure Information; Table 9 Rf Exposure Specifications - ABB MicrOS 410 Installation Manual

Table of Contents

Advertisement

When the MicrOS 410 associates, the alignment LED will begin to flash. The alignment
LED will flash faster as signal strength increases and slower as signal strength decreases.
3.
Rotate the MicrOS 410 on the pole until the alignment LED is blinking as fast as possible.
The alignment LED will stop blinking after 15 minutes. If the alignment LED is needed after
15 minutes, turn it on using the configuration interface for the unit, or power the unit off and
on again.

Safety and Servicing Information

This section contains safety and servicing information.

RF Exposure Information

The Federal Communications Commission (FCC) with its action in ET Docket 96-8 has adopted
a safety standard for human exposure to RF electromagnetic energy emitted by FCC certified
equipment. The MicrOS 410 meets the uncontrolled environmental limits found in OET-65 and
ANSI C95.1, 1991. Proper operation of this device according to the instructions found in this
manual and the hardware and software guides results in user exposure that is substantially below
the FCC recommended limits.
In order to meet the human RF exposure limits required by FCC and Industry Canada, the
installer shall insure separation between transmitter antennas. All persons should maintain a
minimum distance from the unit as specified in
Table 9
Model
MicrOS 410 Single 2.4 GHz
Warning
It is illegal to modify the construction of this product. Modifying the operating frequency or enhancing
the transmit output power through the use of external amplifiers or other equipment is specifically
disallowed by the "Telecommunications Act."
Warning
This device is for outdoor or indoor use with conditions that no harmful interference to authorized radio
stations results from the operation of this device. This device shall not influence aircraft security and/or
interfere with legal communications as defined in the "Telecommunications Act." If this device is found
to cause interference, the operator of this equipment shall cease operating this device immediately
until no interference is achieved.
MicrOS 410 Installation Guide
RF Exposure Specifications
Radios, RF Band
Antennas
External
Table
9.
Maximum EIRP
2.4 GHz EIRP, 36 dBm
Chapter 2
Minimum Distance
25 cm (9.8 in)
26

Advertisement

Table of Contents
loading

Table of Contents