Frigidaire BASELINE Series Use & Care Manual page 41

Concern Potential Cause
Dispenser (Ice & Water)
Dispenser will •
not dispense
ice.
•
•
Ice dispenser •
is jammed.
•
Dispenser will •
not dispense
water.
•
•
Water not •
cold enough.
Water has •
an odd taste
and/or odor.
•
There is no ice in the bin to
be dispensed.
The refrigerator doors are
not completely closed.
Dispenser paddle has
been pressed too long and
the dispenser motor has
overheated.
Ice has melted and frozen
around auger due to
infrequent use, temperature
fluctuations, and/or power
outages.
Ice cubes are jammed
between ice maker and
back of ice container.
Water filter not seated
properly.
Water filter is clogged.
Household water line valve
is not open.
The water dispensing
system is not designed to
chill water.
Water has not been
dispensed for an extended
period of time.
Unit not properly connected
to cold water line.
BEFORE YOU CALL
Common Solution
• See the "Ice maker is not making any
ice" section above.
• Be sure the refrigerator doors are
completely closed.
• The motor overload protector will reset
in about three minutes and then ice can
be dispensed.
• Remove ice container, thaw, and empty
the contents. Clean container, wipe dry,
and replace in proper position. When
new ice is made, dispenser should
operate.
• Remove ice cubes that are jamming the
dispenser.
• Remove and reinstall the water filter. For
Puresource Ultra II, be sure to rotate it
to the right until it stops and the grip
end is vertical.
• Replace filter cartridge. Be sure to rotate
it to the right until it stops and the grip
end is vertical.
• Open household water line valve. See
CONCERN column AUTOMATIC ICE
MAKER.
• Add ice to cup or container before
dispensing water.
• Draw and discard 10-12 glasses of water
to freshen the supply.
• Connect unit to cold water line that
supplies water to the kitchen faucet.
41