Installation - Frigidaire BASELINE Series Use & Care Manual

Tools Necessary:
Phillips Head
or
Quadrex Head
Screwdriver
Components Provided:
Top Hinge
Cover Front
Screw
Top
Hinge
Screw
This Use & Care Guide provides general
installation and operating instructions for
your model. We recommend using a service
or kitchen contracting professional to install
your refrigerator. Use the refrigerator only as
instructed in this Use & Care Guide. Before
starting the refrigerator, follow these
important first steps.
Location
• Choose a place that is near a grounded,
non-GFCI, electrical outlet. Do Not use
an extension cord or an adapter plug.
• If possible, place the refrigerator out of
direct sunlight and away from the range,
dishwasher, or other heat sources.
• The refrigerator must be installed on a
floor that is level and strong enough to
support a fully loaded refrigerator.
• Consider water supply availability for
models equipped with an automatic ice
maker.
(OR)
AND
6mm
Allen Wrench
Top Hinge
Cover Rear
Screw
Lower
Hinge
Screw

INSTALLATION

AND
⅜" and ¼"
Socket
Wrench
CAUTION
D
o Not install the refrigerator where the
temperature will drop below 55°F (13°C) or
rise above 110°F (43°C). The compressor
will not be able to maintain proper
temperatures inside the refrigerator.
Do Not block the toe grille on the lower front
of your refrigerator. Sufficient air circulation
is essential for the proper operation of your
refrigerator.
Installation
Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides & Top
Back

NOTE
I
f your refrigerator is placed with the door
hinge side against a wall, you may have to
allow additional space so the door can be
opened wider.
Door opening
Your refrigerator should be positioned to allow
easy access to a counter when removing
food. For best use of refrigerator drawers and
freezer baskets, the refrigerator should be in a
position where both can be fully opened.
OR
OR
Adjustable ⅜" Fixed
Wrench
⅜ inch (9.5 mm)
1 inch (25.4 mm)
Wrench
7