3.
If your display does not have a DisplayPort connector, connect a DisplayPort video adapter to the
DisplayPort connector of the computer. Then connect a cable (VGA or DVI, depending on your
application) between the adapter and a display.
4.
Turn on power to the computer and the display.
NOTE:
Use the graphics card software or the Windows Display Settings to configure the display as a
mirrored image of the computer display or an extension of the computer display.
Disconnecting cables
1.
You may need to remove the security cable, if one is installed on the rear of the computer.
2.
Disconnect the cables from the ports.
Removing and installing the rear port cover
Removing the rear port cover
1.
Place the computer facedown on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2.
Remove the four screws securing the back cover (1), and then lift the back cover from any cavity to
remove it from the computer (2).
14
Chapter 2 Setup