Locating Internal Components; Removing And Installing Memory; Memory Module Specifications - HP ProOne 600 Hardware Reference Manual
Hp proone 600 g4 21.5-inch all-in-one business pc
hp proone 400 g4 23.8-inch all-in-one business pc
hp proone 400 g4 20-inch all-in-one business pc
Hide thumbs
Also See for ProOne 600:
- Illustrated parts & service map (4 pages) ,
- Hardware reference manual (59 pages) ,
- Hardware reference manual (49 pages)
Table of Contents
Advertisement
Locating internal components
Component
1
2
Removing and installing memory
The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module. A metal shield protects the memory modules.
Memory module specifications
For proper system operation, the memory modules must meet the following qualifications:
Component
Memory modules
Compliance
Pins
Support
Slots
Maximum Memory
Supported
Note
Optical disc drive (optional)
Memory modules
Specification
1.2 volt DDR4-SDRAM memory modules
Unbuffered non-ECC DDR4-2666 MHz SODIMM compliant
Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specification
Support CAS latency 19 DDR4 2666 MHz (19-19-19 timing)
2
16 GB per memory slot, 32 GB total
8 Gbit (base) non-ECC memory technologies single-sided and double-sided SODIMMs
The system will not operate properly if you install unsupported SODIMM
memory. SODIMMs constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
Component
3
RTC battery
4
Hard drive
Locating internal components
23
Advertisement
Table of Contents
