Mitsubishi Electric MELSEC iQ-R Series User Manual page 68

Wiring products
The following describes the devices used for CC-Link IE Controller Network (when Ethernet cables are used).
■Ethernet cable
Use Ethernet cable that meets the following standards.
Ethernet cable
Category 5e or higher, straight cable (double shielded, STP)
Cables for CC-Link IE Controller Network are available from Mitsubishi Electric System & Service Co., Ltd. (Catalogs for cable
are also available.)
In addition, the connector processing of cable length is available for your preference. Please consult your local Mitsubishi
representative.
Type
Straight cable (double shielded, STP)
■Hubs
Use hubs that meet all the conditions listed below. Operation is not guaranteed if the hubs do not meet these conditions.
• Compliance with the IEEE802.3 (1000BASE-T)
• Support of the auto MDI/MDI-X function
• Support of the auto-negotiation function
• Switching hub (layer 2 switch)
*1 A repeater hub is not available.
Type
Industrial switching hub
6 WIRING
66
6.2 Wiring of CC-Link IE Controller Network
Model (Manufacturer)
SC-E5EW series (Mitsubishi Electric System & Service Co., Ltd.)
*1
Connector
RJ45 connector
Model (Manufacturer)
• NZ2EHG-T8N (Mitsubishi Electric Corporation)
• NZ2EHG-T8 (Mitsubishi Electric Corporation) (discontinued)
Type
The following conditioning cables:
• IEEE802.3 (1000BASE-T)
• ANSI/TIA/EIA-568-B (Category 5e)