Advertisement
Replacing the air filter unit
1 )
Turn off the projector and disconnect the power plug from the wall outlet.
Be sure to observe the instructions in "Powering off the projector" in the operating instructions
supplied with the projector.
2 ) Remove the air filter cover.
Remove the air filter cover by turning the air
filter cover fixing screw counter-clockwise
using a Phillips screwdriver until the screw
turns freely.
3 ) Remove the air filter unit.
Hold the knobs in the air filter unit and pull the
air filter unit out of the projector.
4 )
Insert a new air filter unit (replacement filter unit) in the projector.
The air filter unit has the distinction between top and bottom.
(Please check the direction of the arrow
Insert the air filter unit by following the instructions for step 3) in the reverse order.
5 )
Install the air filter cover on the projector and use a Phillips screwdriver to
tighten the air filter cover fixing screw.
Insert the air filter cover by following the instructions for step 2) in the reverse order.
Attention
Turn the main power off before replacing the air filter unit.
Make sure that the projector is stable when attaching the air filter unit, and work in an
environment that is safe, even in the event of the air filter unit dropping.
Be sure to install the air filter unit before turning on the projector. Using the projector without
the air filter unit will cause dirt and dust to accumulate inside the projector and could result in
malfunction.
Dispose of the packaging materials properly after unpacking the product.
Note
For procedures on maintaining the air filter unit, refer to the operating instructions supplied with
the projector.
Web Site : https://panasonic.net/cns/projector/
©
2011
Air filter
cover
Air filter
unit
Knobs
.)
Air filter cover
fixing screw
Advertisement
