Huawei SmartLogger2000 series Quick Manual page 16

4. Tighten the tapping screws using a torque screwdriver.
Guide rail-mounting
Huawei does not provide the SmartLogger guide rail. If the customer chooses this installation mode,
the customer must prepare a 35 mm standard guide rail.
Unit: mm
1. Remove the mounting ears from the
SmartLogger using a Phillips screwdriver.
NOTE
1. Secure the guide rail before mounting the
SmartLogger.
2. Verify that the length of the guide rail is
sufficient for securing the SmartLogger. The
recommended length is 450 mm or greater.
2. Secure the guide rail clamps using the screws
that are removed from the mounting ears.
15