Figure 25: Drag Dlb From Toolchest And Drop In Active Blocks Node; Figure 26: Set Dlb Execution Mode To Sweep (Properties Tab); Figure 27: Start Dlb Execution - GE PACSystems RX7i Cpu Programmer's Reference Manual

Hide thumbs Also See for PACSystems RX7i:

Table of Contents

Chapter 9. Diagnostics

2) Drag and drop the DLB Block from the Toolchest to the Active Blocks node in the Navigator.

Figure 25: Drag DLB from Toolchest and Drop in Active Blocks Node

3) In the DLB block properties, set the Execution Mode to Sweep.

4) Go online to the Controller, and select Programmer Mode. Put the Controller in RUN Mode or

STOP Enabled Mode.

5) Select the DLB Online Operations > Start menu to download the DLB to the controller and start

its execution.

PACSystems* RX7i, RX3i and RSTi-EP CPU Programmer's Reference Manual

Pacsystems rx3i Pacsystems rsti-ep