Specific Safety Instructions For Charging This Unit - DeWalt DXAEPS2 Instruction Manual

exposed to rain or moisture, does not operate normally, or has
been dropped. Contact the manufacturer at 1-888-394-3392 for
more information.
13. Unit shall not be exposed to dripping or splashing and no objects
filled with liquids, shall be placed on the unit.
14. Do not operate this unit near flammable liquids or in gaseous or
explosive atmospheres. Motors in these tools normally spark,
and the sparks might ignite fumes.
15. This unit employs parts (switches, relays, etc.) that produce arcs
or sparks. Therefore, if used in a garage or enclosed area, the
unit MUST be placed not less than 18 inches above the floor.
This Class B digital unit complies with CAN ICES-3(B)/NMB-3(B).
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
for help.
DXAEPS2_ManualENSP_101216.indd 4
NOTICE: Per FCC Part 15, changes or modifications to this equipment
not expressly approved by DEWALT could void your authority to operate
this equipment.
READ ALL INSTRUCTIONS
Specific Safety Instructions for Charging
this Unit
• Don't abuse the cord. Protect the extension cord from being walked
on or pinched particularly at plugs, convenience receptacles, and the
point where it connects to the unit. Never carry the unit by the cord
or yank it to disconnect from receptacle. Pull by the plug rather than
the cord when disconnecting from the unit.
• Ground fault circuit interrupter (GFCI) protection should be
provided on the circuits or outlets to be used. Receptacles are
available having built in GFCI protection and may be used for this
measure of safety.
• IMPORTANT: This unit is delivered in a partially charged state. Fully
charge unit with a household extension cord for a full 40 hours or until
the battery status icon shows 4 solid bars before using for the first
time. You cannot overcharge the unit using the AC charging method.
• To recharge this unit, use only the built-in AC charger with an AC
extension cord (not included) or the supplied DC charger.
• All functions should be turned off when the unit is charging or not
in use. Make sure all functions are turned off before connection to a
power source or load.
Extension Cords
WARNING: Use of an improper extension cord could result in a
risk of fire and electric shock, and will void warranty. Make sure your
extension cord is in good condition. When using an extension cord,
be sure to use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct
4
10/19/2016 3:56:32 PM